Hard Surface Mold prevention
Now, with MoldGuardian™, whenever needed, you can now physically add a “Mold Barrier” to your physical facility (Walls, grow pots, floors, vents, etc.) and protect your facility from mold for One-year or more.
Visible Mold – Spray, wipe or mop MoldGuardian™ onto the visible mold and the areas around the visible mold. There may be mold growing next to the visible mold, but you might not be able to see it yet.
Let MoldGuardian™ stay wet on the surface for at least 10 minutes. Then, with a light scrub brush, scrub the visible mold and the surrounding area to loosen the mold. Rinse with water to remove any visible mold. Allow the excess water to run off and then reapply MoldGuardian™ and let it completely dry.
You can also do this by using a wet rag to remove the now loosened visible mold.
Unseen Mold: If you fog a house or spray MoldGuardian™ into an air duct or behind wallboard, the proprietary feature of MoldGuardian™ will cover the mold, dry and create a mold barrier that will not allow any mold to get into the covered area or out of the covered area. It will not allow nutrients into the covered area for the mold to feed on. Mold spores will not be able to escape the covered area.
TESTED AND PROVEN:
To Learn More About MoldGuardian™ Click on Logo:
